0
0

Delete article

Deleted articles cannot be recovered.

Draft of this article would be also deleted.

Are you sure you want to delete this article?

Sending Tokens To Polygon? How The Bridge Mints Them

0
Posted at

When you send a supported token from Ethereum to Polygon PoS, the bridge locks your original coins and creates an equal amount of mapped tokens on Polygon. Two sets of contracts coordinate that handoff, so you can use the Polygon version while the Ethereum coins stay held until you bridge back.

What does “mapped token” mean?

A mapped token is the Polygon version tied to a specific token on Ethereum. The bridge records which Ethereum token matches which Polygon token, so it knows what to lock and what to release or mint.

For example, say you deposit 10 units of a supported token. The Ethereum contract holds those 10 units, and the mapped Polygon contract creates 10 units for your Polygon address. The total across both chains stays backed: those Polygon units represent the coins held on Ethereum.

How does the deposit reach your Polygon wallet?

First, you approve the bridge to use your tokens, then submit the deposit. A smart contract is software that runs on a blockchain; here, it locks your coins and records the destination address.

Next, Polygon’s relay process reads that record and passes it to the Polygon network. A relay is a system that carries verified messages between chains. The Polygon contract checks the message and mints the mapped amount to the recorded address.

If you are moving a supported token from Ethereum to Polygon PoS, Polygon Bridge uses this lock-and-mint route. Check that the token and destination address shown before signing match your plan; the receiving address is set by the deposit transaction.

You pay Ethereum network fees for the approval and deposit transactions. The destination mint follows after the Ethereum deposit is confirmed and the message is relayed, often within minutes, though network or relay delays can extend the wait. Keep ETH on Ethereum for those fees.

What should you check before sending?

The key test is whether the exact Ethereum token has a mapping on Polygon PoS. A token with the same name or logo may be a different asset, and an unmapped token may not arrive as a usable Polygon token.

  • Confirm the source network is Ethereum and the destination is Polygon PoS.
  • Check the token name and contract address, not just its symbol.
  • Use an address you control on Polygon, and check it carefully.
  • Keep ETH for the Ethereum transactions; keep POL for later Polygon transactions.

I would start with a small amount if you have never used that token pair. Once it arrives, check the token in your wallet or a Polygon app before sending more. If the token is not mapped, or you need a different destination network, this bridge route does not fit; confirm a supported route before moving funds.

0
0
0

Register as a new user and use Qiita more conveniently

  1. You get articles that match your needs
  2. You can efficiently read back useful information
  3. You can use dark theme
What you can do with signing up
0
0

Delete article

Deleted articles cannot be recovered.

Draft of this article would be also deleted.

Are you sure you want to delete this article?